Filter
Top Products
10
Figure 3 Inserting a CWDM GBIC into the switching module
Removing a CWDM GBIC
Use the following procedure to remove a CWDM GBIC. When
storing a CWDM GBIC, place a dust cover over the fiber optic
bores
.
To remove a CWDM GBIC from the switching module:
1 Disconnect the fiber cable from the CWDM GBIC connector.
2 Grasp the extraction tabs (Figure 1) located on either side of
the CWDM GBIC between your thumb and forefinger.
3 Slide the CWDM GBIC out of the Gigabit Ethernet module
slot.
4 If the CWDM GBIC does not slide easily from the module
slot, use a gentle side-to-side rocking motion while firmly
pulling the CWDM GBIC from the slot.
Note: When disposing of a CWDM GBIC, comply with
all national laws and regulations
.
9708FA