Filter
Top Products
- 23 -
nVIDIA N61P/N61S/N61V User's /Manual
・
Swap Floppy Drive
If you have 2 oppy drives, you can change A to B, or change B to A.
・
Boot Up Floppy Seek
During POST, BIOS will determine if the oppy disk drive installed if choose [Enable].
・
Boot Up NumLock Status
This item denes if the keyboard Num Lock key is active when your system is started.
・
Gate A20 Option
[Normal]: The A20 signal is controlled by keyboard controller or chipset hardware.
[Fast]: (default) The A20 signal is controlled by port 92 or chipset specic method.
・
Typematic Rate Setting
Keystrokes repeat at a rate determined by the keyboard controller. When enabled, the
typematic rate and typematic delay can be selected.
・
Typematic Rate (Chars/Sec)
Set the number of times a second to repeat a keystroke when you hold the key down.
The settings are: 6, 8, 10, 12, 15, 20, 24, and 30.
・
Typematic Delay (Msec)
Set the delay time after the key is held down before is begins to repeat the keystroke.
The settings are 250, 500, 750, and 1000.
・
Security Option
This item determines when the system will prompt for password - every time the system
boots or only when enters the BIOS setup.
[Setup]: The password is required only when accessing the BIOS Setup.
[System]: The password is required each time the computer boots up.
・
APIC MODE
This eld is used to enable or disable the APIC (Advanced Programmable Interrupt
Controller). Due to compliance with PC2004 design guide, the system is able to run in
APIC mode. Enabling APIC mode will expand available IRQ resources for the system.
・
MPS Version Control For OS
This item species which version of MPS (Multi-Processor Specication) this mainboard
will use. Leave this item at its default setting.
・
OS Select For DRAM > 64MB
Allow OS2 to be used with >64MB or DRAM. Settings are Non-OS/2 (default) and OS2.
Set to OS/2 if using more than 64MB and running OS/2.
・
Full Screen LOGO Show
This item determines to show the full screen logo when booting.
・
Small Logo(EPA) Show
EPA Logo is the sign at the top of the screen when POST. If you don't want to show this
logo, please set "Disabled".