Filter
Top Products
Connecting Your 3000 Series Secure Gateway Router
8 3000 Series User Guide
Connecting to a PC 22
Before You Begin
You can order your 3000 Series Secure Gateway Router either with the
modules you want already installed, or you can order the modules separately
and install them yourself. For instructions on installing the optional modules,
see Appendix B.
You have the option of mounting your 3000 Series in a rack. See Mounting
the 3000 Series in a Rack on page 9.
Depending on the modules installed in your particular 3000 Series, you need
the following cables. With the exception of a console cable to connect a PC to
your 3000 Series, these cables are not supplied.
To connect . . . You need . . .
Analog Voice
module
The type of cable you use depends on the interface type
that the equipment you connect to supports.
Compliance with applicable regulations depends on the
use of shielded cables.
DDS module RJ-48S, 8-conductor straight-through cable.
Ethernet Ethernet 10BaseT (Unshielded Twisted Pair)
straight-through cable.
Fractional E1
module
Cable with an RJ-48C connector (TIA 568B
compatible).
Fractional T1
module
Cable with an RJ-48C connector (TIA 568B
compatible).
ISDN module RJ-45, 8-conductor straight-through cable.
For ISDN S/T modules, you also need an external NT1
device and the appropriate cable to connect the NT1 to
the ISDN wall jack. The cable for this connection
depends on the NT1 device.
SDSL module Cable with an RJ-48C connector (TIA 568B
compatible).