Filter
Top Products
Onboard Serial Port 1/Port 2
Select an address and corresponding interrupt for the first and second
serial ports.
The choice: 3F8/IRQ4, 2F8/IRQ3, 3E8/IRQ4, 2E8/IRQ3, Disabled,
Auto.
UART Mode Select
The choice: IrDA, ASKIR, Normal.
RxD, TxD Active
This item allows you to choose Hi-Active or Low-Active of TX and
RX signlal, which depends on different H/W requirement. This field is
not recommended to change its default setting for avoiding any error in
your system
The Choice: Hi, Hi / Hi, Lo (Default) / Lo, Hi / Lo, Lo.
IR Transmission Delay
This item allows you to Enable/Disable IR tranismission delay.
The choice: Enabled, Disabled.
IR2 Duplex Mode
This item allows you to select the IR half/full duplex function.
The Choice: Half, Full.
Onboard Parallel Port
This item allows you to determine onboard parallel port controller I/O
address setting.
The choice: 378/IRQ7, 278/IRQ5, 3BC/IRQ7, Disabled.
Parallel Port Mode
Select an operating mode for the onboard parallel (printer) port. Select
Normal, Compatible, or SPP unless you are certain your hardware and
software both support one of the other available modes.
The choice: SPP, EPP, ECP, ECP+EPP, Normal.
73
TR-5001 User Manual