Filter
Top Products
Menu functions> 75
USB
MENU
This menu controls the operation of the printer’s USB data
interface.
N
ETWORK
MENU
This menu controls the operation of the printer’s 10Base-T/
100Base-TX network interface.
ITEM SETTINGS EXPLANATION
SOFT RESET ENABLE /
DISABLE
Enables or disables the SOFT RESET
command.
SERIAL NUMBER ENABLE /
DISABLE
Specifies whether to ENABLE or DISABLE
a USB serial number.
The USB serial number is used to identify
the USB device connected to your PC.
SPEED 12 / 480 Mps Selects the interface speed
NOTE:
When you have changed any settings in the USB MENU, turn
the printer OFF, then ON again.
ITEM SETTINGS EXPLANATION
TCP/IP ENABLE /
DISABLE
Enables or disables this network protocol.
NETBEUI ENABLE /
DISABLE
Enables or disables this network protocol.
IP ADDRESS SET AUTO / MANUAL Specifies whether IP address allocation is
automatic (DHCP) or manually assigned.
IP ADDRESS xxx.xxx.xxx.xxx Current assigned IP address. To change,
press ENTER and use +/– buttons to
increment 1st octet, then press ENTER
again to move on to next octet. When 4th
octet has been set, press ENTER again to
register new address.
SUBNET MASK xxx.xxx.xxx.xxx Current assigned subnet mask. To
change, proceed as above.
GATEWAY
ADDRESS
xxx.xxx.xxx.xxx Current assigned gateway address. To
change, proceed as above.
FACTORY
DEFAULTS
EXECUTE Reloads the settings present when the
unit was setup by the manufacturer.
WEB ENABLE /
DISABLE
Enables or disables Web config. facility.
TELNET ENABLE /
DISABLE
Enables or disables Telnet config. facility.