Filter
Top Products
CX2032 MFP User’s Guide Installing upgrades
130
Memory upgrade
This section explains how to install additional RAM memory into your
MFP as a memory upgrade.
The model comes equipped with 256MB of main memory.This can be
upgraded with an additional memory board containing either 256MB or
512MB, giving a total memory capacity of either 512MB or 768MB
maximum.
1. Switch the MFP off and disconnect the AC power cable.
2. Pull open the access panel on the side of the machine.
Side
cover open.eps
3. Carefully remove the new memory board from its wrapping. Try
to handle the board only by its short edges, avoiding contact with
any metal parts as far as possible. In particular, avoid touching
the edge connector.
4. Notice that the memory board has a small cutout in the edge
connector, which is closer to one end than the other.
RAM
Board.eps
5. Identify the RAM expansion slot (1) in the machine.
6. Hold the new memory board by its short edges, so that the edge
connector faces in towards the RAM expansion slot, and the small
cutout is closer to the bottom of the machine.