Filter
Top Products
11
1
EN
Power supply
Power supply
3 Close the battery cover
completely by pressing to the
direction A, then sliding to the
direction B.
• If the “hour” indicator flashes in the
display, see “Setting time and date
[Time & Date]” (☞
P.15).
Battery indicator
The battery indicator on the display changes
as the batteries loose power.
• Be sure to stop the recorder before
replacing the batteries. Unloading the
batteries while the recorder is in use may
cause a malfunction such as corrupting
the le, etc. If you are recording into a le
and the batteries run out, you will loose
your currently recorded le because the
le header will not be able to close. It is
crucial to change the batteries once you
see only one Hash mark in the battery
indicator.
• If it takes longer than 1 minute to replace
the dead batteries or if you take the
batteries in and out repeatedly at short
intervals, you may have to reset the time
when you have loaded fresh batteries
(☞ P.15).
• Remove the batteries if you are not going
to use the recorder for an extended period
of time.
• When playing a voice/music le, the
recorder may be reset due to the
reduction of the voltage output of the
batteries depending on the volume level
even if [8] is displayed in the battery
indicator. In this case, lower the volume of
the recorder.
• When replacing rechargeable batteries, be
sure to use Ni-MH rechargeable batteries
(optional). The use of other manufacturers'
products can damage the recorder and
should be avoided.
"
For WS-400S:
• This recorder cannot charge
rechargeable batteries.
• When [:] appears on the display, replace
the batteries as soon as possible. When
the batteries are too weak, [
] and
[Battery Low] appears on the display and
the recorder shuts down.
Notes
• Manganese batteries may not be used in
this recorder.
• When changing batteries, AAA alkaline
batteries or Olympus Ni-MH rechargeable
batteries are recommended.