Filter
Top Products
14
Step 4 : Use the default folder, click Next
Step 5 : Click Install, then Finish
c. Connection
Connect the SAM3G to the PC using the supplied USB cable. After connection, the PC will
automatically detect the SAM3G and run the
3G_Watcher.
To set up the data profile, go to the “Tools” option, select “Connections” -> “Profile” then enter
Profile name, User name, Password, Access Point Name (APN) and Connection type. PDP type
default is IP.
8.2 Using the Serial RS232 port
The SAM3G has 2 different configurations for the serial port : General configuration and Meter
configuration.
a. General configuration :
In this configuration, the SAM3G’s default terminal speed is 115200bps, data format is 1+8+1.
There are only 4 serial data signals s
upported, namely RXD, TXD, RTS and CTS.
b. Meter configuration :
In this configuration, the SAM3G will be controlled by an internal micro-controller, its default
terminal speed is 9600bps, 1+8+1. Ther
e are 5 serial data signals supported, namely RXD,TXD,
RTS,CTS and DCD.
c. Connection :
To test the serial port configuration, follow these steps :
- Insert the USIM c
ard into the SAM3G
-
Connect the Antenna
- Connect the SAM3G to the PC’s COM port using the supplied serial cable (RJ45-DB9).
- On the PC, run a terminal program, ex. HyperTerminal, set the program speed at either
115200bps, or 9600bps.
- Connect the 12Vdc to the SAM3G Red+Black wires
UK / Europe Office
Tel: +44 (0)8700 434040
Fax: +44 (0)8700 434045
info@omniinstruments.co.uk
www.omniinstruments.co.uk
Australia / Asia Pacific Office
Tel +61 (0)282 442 363
Fax +61 (0)294 751 278
info@omniinstruments.com.au
www.omniinstruments.com.au
USA / Canada Office
Tel +1-866-849-3441
Fax +1-866-628-8055
info@omniinstruments.net
www.omniinstruments.net