PAC OS-4 Network Router User Manual


  Open as PDF
of 4
 
Pacic Accessory Corporation - Santa Ana, CA 92705
techsupport@pac-audio.com • Voice: 866-931-8021 • Fax: 714-835-3233 • www.pac-audio.com
Page 4
09-14-09
1. Turn ignition on. The red ignition LED inside the interface will turn on and the +12v accessory wire will turn on.
2. Turn on the radio and check balancing and fading. Note: The RPO code UQA (standard digital Bose® amplier) will not fade as the
rear outputs of aftermarket radio do not adjust the amplier.
3. Pressing the OnStar® button will turn off the rear speakers and allow the OnStar® audio to be heard in the two front speakers. The
OnStar® active red LED will also turn on. When OnStar® disconnects, the radio will un-mute or turn back on and the OnStar® LED will
turn off.
4. Turn off vehicle and remove key. RAP will be active and keep the radio on for 10 minutes or until the drivers door is opened.
5. The red ignition On LED and radio will turn off when RAP turns off or the drivers door is opened.
6. Pressing the Mute/OnStar® button on the steering wheel for 1.5 seconds will also activate Onstar®.
DISCLAIMER: Under no circumstances shall the manufacturer or the distributors of the OS-4 parts be held liable for consequential damages sustained
in connection with the OS-4. The manufacture and it’s distributors will not, nor will they authorize any representative or any other individual to
assume obligation or liability in relation to the OS-4 other than its replacement.
OnStar® is a registered trademark of OnStar® Corporation.
Bose® is a registered trademark of Bose®
Testing and Verifying Operation
 previous