Panasonic KX-TC1200ALF Tablet User Manual


 
(TALK) and
Indicator
(CH)
(LOUD)
(REDIAL)
To redial the last number dialled
Press (TALK) (REDIAL).
To select the handset receiver
volume
Press (LOUD) while talking.
Each time you press the button, the
volume level will change from LOW
(preset) to HIGH.
If noise interferes with the
conversation
Press (CH) to select a clearer channel or
move closer to the base unit.
Backlit handset keypad
The handset dialling buttons will light when
you press a button or lift the handset off the
base unit, or when a call is received. The
lights will go out a few seconds after
pressing a button, lifting the handset or
answering a call.
1
Press (TALK).
The TALK indicator lights.
If an alarm tone sounds, see 6-E.
2
Dial a phone number.
3
To hang up,
press (TALK) or place the
handset on the base unit.
The indicator light goes out.
For best operating performance, see
section 6-C.
When dialling additional numbers after
speed dialling [eg, AUTO (3-B), DIRECT
(4-B) or REDIAL], make sure that speed
dialling is finished before entering
additional digits.
Otherwise, the unit may not dial correctly.
Selecting the ringer volume
The TALK indicator light must be off.
To select HIGH (preset) or LOW,
press (RINGER).
Each time you press the button, the
ringer volume will change and the
selected volume will ring.
To turn the ringer OFF,
press and hold (RINGER) until a beep
sounds.
To turn the ringer ON,
press (RINGER).
If the handset is off the base unit,
press (TALK).
You can also answer a call by pressing
any dialling button (0) to (9),
($)
or
(—Any Key Talk).
OR
If on the base unit,
just lift up.
(TALK) and Indicator
(RINGER)
2-A Making Calls
2-B Answering Calls
2
Making/Answering Calls
Section 2
For New Zealand Users Only:Additional Security Feature
In the event that a call cannot be made from the handset following a power interruption,
disconnect the base unit from the line momentarily then reconnect it. Turn the handset off, and
replace it on the base unit.
This will re-establish the security system and the handset can be used as before.