Filter
Top Products
– 9 –– 8 –
English
1. Introduction
Names and functions
Motor Nameplate
Frame
O ring
Bracket
Oil seal
Oil seal
Motor accessories
(only for single phase version)
Gear head accessories
Gear head nameplate
Screw
Nut
Flat washer
Shaft
Output shaft
Earth ground terminal
M4 x 6 stainless steel
with spring and flat washer
Key
Quick connect
tab (Faston)
#187
Capacitor
Capacitor cap
Wiring
nameplate
2. Installation
Motor
Installation location
Install the motor as described to prolong the motor lifetime in a place where;
(1) is free from rain and direct sunlight.
(2) is free from vibration 4.9 m/s
2
or more; shock, dust, iron powder or oil mist; splash of water. oil
and grinding fluid; and away from flammable materials, corrosive gas (H
2S, SO2, NO2, Cl2, etc.)
or flammable gas.
(3) is enough ventilated dry and clean keeping oil, water, dust and heat away.
(4) you can check and clean the motor easily.
(5) is not in a closed environment where the motor temperature may increase. This may result in
the motor life shortened.
Environmental condition
Description
–10°C to 40°C (no freezing) *
1
85% RH or below (no dewing)
–10°C to 60°C (no freezing) *
2
4.9 m/s
2
or below (10 to 60 Hz)
Lower than 1000 m.
Item
Ambient temperature
Ambient humidity
Storage temperature
Vibration
Altitude
*
1) Measurement taken at a point 5 cm from the motor.
*
2) Allowable range for a relatively short period, for example, during transportation.
Installation
The motor can be installed vertically or horizontally but leadwires should be directed downward.
Keep the motor away from oil, water and dust
(1) Don't run the cable in water or oil.
(2) Don't expose the motor to splashing oil or
water.
Oil, water
Cable
Motor
*
Don't remove the nameplate.