Filter
Top Products
4
ET-MD77SD3
HD-SDI/SD-SDI Board for DLP™ Projector
S P E C F I L E
As of December 2006
204
(8-1/32˝)
21432
(8-7/16˝)(1-1/4˝)
Specifications
Power supply: Provided from the DLP™ projector
Power consumption: Projector power consumption increases approximately 10 W
Terminals: Serial input: BNC x 1
4:2:2 digital serial component signal: SMPTE 259M compliant,
480i, 576i
HD digital serial component signal: SMPTE 292M compiant,
720/60p, 720/50p, 1035/60i, 1080/60i, 1080/50i,
1080/25p, 1080/24p, 1080/24sF, 1080/30p
Serial output: BNC x 1, active through
LAN: RJ-45 x 1, 10Base-T/100Base-TX for network connection
Dimensions (W x H x D): 204 x 32 x 214 mm (8-1/32˝ x 1-1/4˝ x 8-7/16˝)
Weight: 290 g (10.2 lbs.)
Operating temperature: 0°C – 40°C
Operating humidity: 10% – 80% (no condensation)
NOTE: Use connection cables of 5CFB or higher (ex. 5CFB, 7CFB, 5CFTX, etc.).
720/50p signals can be input only when this unit is used with the PT-DW10000, PT-D10000,
PT-DW7000 or PT-D7700.
Weights and dimensions shown are approximate.
Specifications subject to change without notice.
DLP and DLP logo are trademarks of Texas Instruments.
This board is designed for use with the DLP™ projectors. It enables the input of a HD digital serial component
signal (SMPTE292M-compliant). Remote control of the projector is also possible from an external computer
connected via LAN.
NOTE: Please use the module only on the specified Panasonic DLP™ projector.
Dimensions
unit: mm
(Dimensions given in inches are approximate.)
Note: This illustration is not drawn to scale.