Filter
Top Products
8. Programmable Features
75
8.2 Basic features
Code #00: Setting the Quick Setup
QUICK SETUP
PRESS SET
See page 23 for details.
Code #01: Setting the date and time
SET DATE & TIME
PRESS SET
See page 31 for details.
Code #02: Setting your logo
YOUR LOGO
PRESS SET
See page 32 for details.
Code #03: Setting your fax number
YOUR FAX NO.
PRESS SET
See page 34 for details.
Code #04: Printing a sending report
SENDING REPORT
MODE=ERROR [±]
To print a sending report for fax transmission
results (page 54).
“ERROR” (default): A sending report will be
printed only when fax transmission fails.
“ON”: A sending report will be printed after every
transmission.
“OFF”: Sending reports will not be printed.
Code #06: Changing the ring setting in FAX
ONLY mode
FAX RING COUNT
RINGS=3 [±]
To change the number of rings before the unit
answers a call in FAX ONLY mode.
You can select “1”, “2”, “3” (default) or “4”.
Code #06: Changing the ring setting in
TAM/FAX mode
TAM RING COUNT
RINGS=3 [±]
To change the number of rings before the unit
answers a call in TAM/FAX mode. You can select
“2”, “3” (default), “4”, “5”, “6”, “7” or “TOLL
SAVER”. See page 59 for details.
Note:
L You can also program this feature with the
handset (page 84).
Code #10: Changing the maximum recording
time for incoming messages
RECORDING TIME
MODE=3 MIN [±]
“1 MIN”, “2 MIN” or “3 MIN” (default): 1
minute to 3 minutes.
“GREETING ONLY”: Only plays your greeting
message.
Note:
L If you select “GREETING ONLY”, the unit will
answer a call with the greeting message, and
then hang up. The unit will not record any
incoming messages.
L You can also program this feature with the
handset (page 84).
Code #11: Setting the remote operation ID
REMOTE TAM ID
ID=11
1. Press {MENU}.
2. Press {#}, then {1}{1}.
3. Enter a 2-digit number (00–99).
L The default ID is “11”.
4. Press {SET}.
5. Press {MENU}.
Note:
L You can also program this feature with the
handset (page 85).
Code #13: Setting the dialing mode
DIALING MODE
MODE=TONE [±]
If you cannot make calls, change this setting
depending on your telephone line service.
“TONE” (default): For tone dial service.
“PULSE”: For rotary pulse dial service.
Note:
L You can also program this feature with the
handset (page 86).
Code #16: Setting the recording paper size
PAPER SIZE
=LETTER [±]
“LETTER” (default): Letter or legal size paper.
“A4”: A4 size paper.
FPG391_en.book Page 75 Friday, July 16, 2004 5:38 PM