Filter
Top Products
ENGLISH-27
Basic operation
POWER button on the projector
POWER button status
Red
Illuminated
The projector is in standby mode and image projection
is possible by pressing the POWER button.
A picture is being projected.
The lamp is cooling down after the power has been
turned off or while direct power off function is
operating.
The projector is preparing for projection after the
power has been turned on while the POWER button
on the projector is illuminated orange. (After a short
period, a picture will be projected.)
The projector is preparing for projection after the
power has been turned on while the POWER button
on the projector is illuminated red. (After a short
period, a picture will be projected.)
Flashing
Illuminated
Illuminated
Flashing
Green
Orange
Projector status
Direct power off function
You can disconnect the mains lead during projection or immediately after
use and move the projector. The cooling fan will operate by the internal
power supply to cool down the lamp.
BWhen this function is used, it may take more time for the lamp to turn back
on again compared to when the lamp cools down with the mains lead
connected.
BDo not put the projector in a bag while the POWER button on the
projector is illuminated.
CAUTION
If not using the projector for an extended period of time, disconnect the
mains plug from the mains socket.
BIf dust builds up on the mains plug, the resulting humidity may damage the
insulation, which could result in fire.
BThis projector continues to draw approximately 4 W of power even when
the power is turned off.