Filter
Top Products
S PEC F ILE
PT-DW10000
3-Chip DLP™ Projector
As of July 2007 < 2 >
Specifications
Main Unit
Power supply: North America:
Europe, Asia
Power consumption:
DLP™ chip: Panel size:
Display method:
Pixels:
Lens:
Lamp:
Screen size:
Brightness*
1
:
Center-to-corner uniformity*
1
:
Contrast*
1
:
Resolution:
Scanning frequency: RGB:
YP
BPR (YCBCR):
S-Video/Video:
Optical axis shift*: Vertical:
Horizontal:
Keystone correction range:
Installation:
Terminals: DVI-D IN:
RGB1 IN:
Y, P
B, PR
R, G, B:
RGB2 IN:
Y, P
B, PR
R, G, B:
VIDEO IN:
VIDEO OUT:
S-VIDEO IN:
LAN:
SERIAL IN*
4
:
SERIAL OUT*
4
:
REMOTE 1 IN:
REMOTE 1 OUT:
REMOTE 2 IN:
120 V AC, 20 A, 60 Hz
220–240 V AC, 15 A, 50/60 Hz
1,450 W (25 W in standby mode with fan stopped)
0.95˝ diagonal (16:9 aspect ratio)
DLP™ device x 3 (R, G, B), DLP™ projection system
2,073,600 (1,920 x 1,080) x 3, total of 6,220,800 pixels
Optional powered zoom/focus lenses
250 W UHM™ lamp x 4
70–600 inches, 16:9 aspect ratio
(70–300 inches with the ET-D75LE5, 16:9 aspect ratio)
10,000 lumens (four-lamp operation mode)
90%
5,000:1 (full on/full off, in dynamic iris 3 mode)
1,920 x 1,080 pixels (Input signals that exceed this resolution will be
converted to 1,920 x 1,080 pixels.)
Horizontal: 15–100 kHz, Vertical: 24–120 Hz*
2
,
Dot clock: 20–162 MHz
480i: f
H 15.75 kHz; fV 60 Hz, 576i: fH 15.63 kHz; fV 50 Hz,
480p: f
H 31.50 kHz; fV 60 Hz, 576p: fH 31.25 kHz; fV 50 Hz,
720/60p: f
H 45.00 kHz; fV 60 Hz, 720/50p: fH 37.5 kHz; fV 50 Hz,
1035/60i: f
H 33.75 kHz; fV 60 Hz, 1080/60i: fH 33.75 kHz; fV 60 Hz,
1080/50i: f
H 28.13 kHz; fV 50 Hz, 1080/25p: fH 28.13 kHz; fV 25 Hz,
1080/24p: f
H 27.00 kHz; fV 24 Hz, 1080/24sF: fH 27 kHz; fV 48 Hz,
1080/30p: f
H 33.75 kHz; fV 30 Hz, 1080/60p: fH 67.5 kHz; fV 60 Hz,
1080/50p: f
H 56.25 kHz; fV 50 Hz
Horizontal: 15.75/15.63 kHz, Vertical: 50/60 Hz,
(NTSC, NTSC4.43, PAL, PAL60, PAL-N, PAL-M, SECAM)
±50% (±40° with the ET-D75LE6) from center of screen, powered
±30% (±20° with the ET-D75LE6) from center of screen, powered
Vertical: ±40° (±22° with the ET-D75LE5, ±28° wih the ET-D75LE6)
Ceiling/floor, front/rear
DVI-D 24-pin x 1, DVI 1.0 compliant, HDCP compatible, single link
BNC x 5
Y: 1.0 p-p, 75 ohms (incl. sync signal), P
B/PR: 0.7 Vp-p, 75 ohms
0.7 Vp-p (1.0 Vp-p for sync on G), 75 ohms
HD/SYNC: 1.4–5 Vp-p, positive/negative automatic, 75 ohms
VD: 1.4–5 Vp-p, positive/negative automatic, 75 ohms
NOTE: HD/SYNC, and VD terminals do not accept 3-value direct sync signals.
D-sub HD 15-pin x 1
Y: 1.0 p-p, 75 ohms (incl. sync signal), P
B/PR: 0.7 Vp-p, 75 ohms
0.7 Vp-p (1.0 Vp-p for sync on G), 75 ohms
HD/VD/SYNC: TTL, high impedance, positive/negative automatic
VD: 1.4–5 Vp-p, positive/negative automatic, 75 ohms
NOTE: HD/SYNC, and VD terminals do not accept 3-value direct sync signals.
BNC x 1, 1.0 Vp-p
BNC x 1, 1.0 Vp-p, active through
Mini DIN 4-pin x 1
Y: 1.0 Vp-p, C: 0.286 Vp-p, 75 ohms (S1 signal compatible)
RJ-45 x 1, 10Base-T/100Base-TX, compatible with PJLink™ (class 1)
D-sub 9-pin x 2 (RS-232C compliant, RS-422 compliant)
D-sub 9-pin x 1 (RS-422 compliant)
M3 jack x 1 for wired remote control
M3 jack x 1 for link control
D-sub 9-pin x 1 for external control (parallel)