Filter
Top Products
S PEC F ILE
PT-DZ12000
3-Chip DLP™ Projector
As of July 2008 < 2 >
Specifications
Main Unit
Power supply: North America:
Europe, Asia
Power consumption: North America:
Europe, Asia
DLP™ chip: Panel size:
Display method:
Pixels:
Lens:
Lamp:
Screen size:
Brightness*
1
:
Center-to-corner uniformity*
1
:
Contrast*
1
:
Resolution:
Scanning frequency: RGB:
YPBPR (YCBCR):
S-Video/Video:
Optical axis shift*
3
: Vertical:
Horizontal:
Keystone correction range:
Installation:
Terminals: DVI-D IN:
RGB1 IN:
R, G, B:
Y, PB, PR
120–240 V AC, 16–9.0 A, 50/60 Hz (3-wire single-phase)
220–240 V AC, 9.5 A, 50/60 Hz (3-wire single-phase)
1,600–1,500 W (10-15 W in standby mode with fan stopped)
1,500 W (15 W in standby mode with fan stopped)
0.96˝ diagonal (16:10 aspect ratio)
DLP™ chip x 3 (R, G, B), DLP™ projection system
2,304,000 (1,920 x 1,200) x 3, total of 6,912,000 pixels
Optional powered zoom/focus lenses
300 W UHM™ lamp x 4
70–600 inches, 16:10 aspect ratio
(70–300 inches with the ET-D75LE5, 16:10 aspect ratio)
12,000 lumens (four-lamp operation mode)
90%
5,000:1 (full on/full off, in dynamic iris 3 mode)
1,920 x 1,200 pixels (Input signals that exceed this resolution will be
converted to 1,920 x 1,200 pixels.)
Horizontal: 15–100 kHz, Vertical: 24–120 Hz*
2
,
Dot clock: 20–162 MHz
480i: fH 15.75 kHz; fV 60 Hz, 576i: fH 15.63 kHz; fV 50 Hz,
480p: fH 31.50 kHz; fV 60 Hz, 576p: fH 31.25 kHz; fV 50 Hz,
720/60p: fH 45.00 kHz; fV 60 Hz, 720/50p: fH 37.50 kHz; fV 50 Hz,
1035/60i: fH 33.75 kHz; fV 60 Hz, 1080/60i: fH 33.75 kHz; fV 60 Hz,
1080/50i: fH 28.13 kHz; fV 50 Hz, 1080/25p: fH 28.13 kHz; fV 25 Hz,
1080/24p: fH 27.00 kHz; fV 24 Hz, 1080/24sF: fH 27.00 kHz; fV 48 Hz,
1080/30p: fH 33.75 kHz; fV 30 Hz, 1080/60p: fH 67.50 kHz; fV 60 Hz,
1080/50p: fH 56.25 kHz; fV 50 Hz
Horizontal: 15.75/15.63 kHz, Vertical: 50/60 Hz,
(NTSC, NTSC4.43, PAL, PAL60, PAL-N, PAL-M, SECAM)
±55% (±44% with the ET-D75LE6) from center of screen, powered
±20% (±15% with the ET-D75LE6) from center of screen, powered
Vertical: ±40° (±22° with the ET-D75LE5, ±28° wih the ET-D75LE6),
with geometric adjustment: vertical ±10°, horizontal ±15°
Ceiling/floor, front/rear
DVI-D 24-pin x 1, DVI 1.0 compliant, compatible with HDCP, compati-
ble with single link only,
480p, 576p, 720/60p, 720/50p, 1080/60i, 1080/50i, 1080/24p,
1080/24sF, 1080/25p, 1080/30p, 1080/60p, 1080/50p
VGA (640 x 480)–WUXGA*
4
(1,920 x 1,200), compatible with non-
interlaced signals only, dot clock: 25–162 MHz
BNC x 5
G: 0.7 Vp-p (1.0 Vp-p for sync on G), 75 ohms,
B, R: 0.7 Vp-p, 75 ohms
HD, VD, SYNC: 1.4–5.0 Vp-p, positive/negative automatic
Y: 1.0 p-p, 75 ohms (incl. sync signal), PB/PR: 0.7 Vp-p, 75 ohms
0.7 Vp-p (1.0 Vp-p for sync on G), 75 ohms
NOTE: HD/SYNC, and VD terminals do not accept 3-value direct sync signals.