Filter
Top Products
ENGLISH - 36
Settings
OPTION menu
When you change the input method, the guidance
appears in the upper right corner of the screen. The
following display methods are available. Press I H to
cycle through the options.
You can switch the logo on/off that is displayed when
starting up the projector. Press I H to select the
required option. STARTUP LOGO will be displayed for
30 seconds.
ON Active
OFF Deactive
USER Display the original text
Q Editing the original text
If you select USER, you can display the 2 lines of
original text up to 40 characters in 1 line instead of
the logo.
1. Select USER and press ENTER.
2. Select the required line to enter or edit the original
text, and press ENTER.
3. Use F G I H to specify the location of the
required character and press ENTER.
The selected character will be displayed in the box.
Select DELETE to delete the last entered character
and press ENTER.
4. Repeat the step 3 until you finish the text to display
in a line.
5. Select OK and press ENTER to set the entered
text in a box.
Press G and edit the TEXT2 if you need to, and
repeat the step 3 - 5.
You can switch the function of the COMPUTER2 IN/
1OUT terminal.
INPUT COMPUTER2 IN
OUTPUT COMPUTER1 OUT
You can check the remaining amount of the ARF (Auto
Rolling Filter). The colour of the bar scale is indicating
the condition of the ARF.
Yellow The filter remaining amount is getting
low.
Red No more remaining.
You can check how long the lamp has been used.
INPUT GUIDE
Options Function
OFF Turn off the guidance.
SIMPLE
Display the input method by text.
The INPUT GUIDE will go out after
5 seconds without any operation.
DETAILED
Display the input method by graphic.
The INPUT GUIDE will go out after
10 seconds without any operation.
If you select any COMPUTER
terminal which has no signal, the
computer connection guidance will
be displayed. See “Computer
connection guidance” on page 48.
STARTUP LOGO
Remote control Control panel
See “Navigating through the MENU” on page 29.
See “Main menu and Sub-menu” on page 30.
OK CANCEL
DELETE
TEXT CHANGE
COMPUTER2 SELECT
FILTER REMAINING
NOTE:
• See “Replacing the ARF (Auto Rolling Filter)” on
page 42.
• After you replace the ARF, FILTER REMAINING should
be reset to “0” by pressing the ENTER button for
3 seconds.
LAMP RUNTIME
NOTE:
• LAMP RUNTIME is a relevant matter for lamp
replacement timing. See “Replacing the Lamp unit” on
page 43.
• When the lamp unit is replaced with the new one
(ET-LAF100), the setting will be reset to “0”.