Filter
Top Products
ENGLISH - 10
Preparation
Read this first
When you start the projection for the first time, the minimum required setting screen for projection will be displayed.
J LANGUAGE
Select the required language setting.
Press F G I H buttons of the Remote control or
Control panel on the projector to highlight the
required language, and press ENTER to proceed to
the next setting.
J OPTION
Select the current projection method and fan speed
setting. If you need return to the previous setting,
press the RETURTN button.
INSTALLATION
Press I H buttons of the Remote control or
Control panel on the projector to select the
required installation method. Press G to proceed to
the ALTITUDE setting.
ALTITUDE
If you use the projector at high elevation, the
ALTITUDE setting need to be HIGH to set the fan
speed high. Press I H to select the required
option. If you need to return to the INSTALLATION,
press F .
LOW The fan speed is low.
HIGH The fan speed is high.
Press the ENTER button to start the projection.
Once you finish the minimum requirement setting, it will not be displayed again unless the projector is
initialized. See “INITIALIZE ALL” on page 36.
You can change the settings from the MAIN MENU. See “Menu Navigation” on page 27.
Minimum required setting screen
LANGUAGE
SELECT
ENTER
PLEASE SELECT LANGUAGE
INSTALLATION
OPTION
FRONT/DESK
ALTITUDE
LOW
SELECT
ENTER
RETURN
FRONT/DESK
Setting on a desk/floor and
projecting from front
FRONT/CEILING
Mounting in the ceiling and
projecting from front
REAR/DESK
Setting on a desk/floor and
projecting from rear
REAR/CEILING
Mounting in the ceiling and
projecting from rear
NOTE:
• At 1 400 - 2 700 m (4 593 - 8 858 ft) sea level, the
setting must be HIGH.
• The loudness of fan noise depends on the ALTITUDE
setting.