Filter
Top Products
ENGLISH-51
Care and maintenance
Remedy
Problem
Indicator
display
Flashing (red)
It is nearly time to
replace the lamp
unit.
Illuminated (red)
An abnormality has been detected in the lamp
circuit.
BDoes “REPLACE
LAMP” appear on
the screen after
the projector is
turned on?
BThis occurs when
the operation time
for the lamp unit is
nearing 1 800
hours (when
“LAMP POWER”
has been set to
“HIGH”). Ask your
dealer or an
Authorised
Service Centre to
replace the lamp
unit.
Possible
cause
BThe power may
have been turned
on straight away
after it was turned
off.
BWait for a while
until the lamp unit
cools down before
turning the power
back on again.
BThere may be an
abnormality in the
lamp circuit.
BDisconnect the
mains lead by
following the
procedure on
page 26, and then
contact an
Authorised
Service Centre.
LAMP indicator
NOTE:
BBe sure to disconnect the mains lead by following the procedure given
in “Turning off the power” on page 26 before carrying out any of the
procedures in the “Remedy” column.
BIf the power turns off after the TEMP indicator has illuminated, it means
an abnormality has occurred. Please contact an Authorised Service
Centre so that the necessary repairs can be made.