Filter
Top Products
ENGLISH - 25
Basic Operation
Remote control operation
You can operate the projector with the remote control
within the remote range 15 m (49'2"), approximately
± 30° vertically and horizontally.
Q Facing to the projector
Make sure the remote control emitter is facing to
the remote control signal receptor of the projector
when pressing the buttons to operate.
Q Facing to the screen
Make sure the remote control emitter is facing to
the screen when pressing the buttons to operate
the projector. The signal will be reflected off the
screen to the projector.
The operating range may differ due to the screen
material, and this function may not be effective with a
translucent screen.
If you need to readjust the projected image
position while projecting or when AUTO SETUP
in OPTION menu is set to OFF, press the AUTO
SETUP button.
The projector will detect a RGB signal by SIGNAL
SEARCH system and adjust the setting of POSITION,
DOT CLOCK and CLOCK PHASE in POSITION menu
automatically.
Operating range
NOTE:
• See “About Your Projector” on page 14 to confirm the
position of the remote control signal emitter and
receptor.
• Do not let strong light shine onto the signal receptor.
The remote control may malfunction under strong light
such as fluorescent.
• If there are any obstacles between the remote control
emitter and the remote control signal receptor, the
remote control may not operate correctly.
Setting up the image position automatically
NOTE:
• If SIGNAL SEARCH setting in OPTION menu is set to
OFF, select the required signal manually first. See
“Switching the input signal” on page 26.
• If the dot clock frequency is 108 MHz or higher, AUTO
SETUP is not effective.
• If the projected image is too dark or blurred around the
edge, AUTO SETUP may stop the processing before
complete the adjustment and return to the previous
setting. Project a much clearer or lighter image and try
again.
Screen Projected image