Filter
Top Products
Part Names and Functions
9
Operating Instructions
■ Control panel
Panel Name Description
Contrast/
Remaining
Film
Indicator
This lamp indicator notifies the user when the time to replace the thermal transfer
film is approaching (estimated) and of the printing contrast used during copying.
Indicator off: Normal printing contrast
Indicator on: Darker than normal printing contrast
Indicator flashing*: Almost time to replace the thermal transfer film
(Note that only about 15 more sheets may be
copied when this indicator starts flashing.)
Replacement film (UG-6001) is separately available
from the dealer where you purchased your unit.
* The flashing indicator will go out after the power is turned off, or the
printer has been opened and closed. (When copying is performed, this
indicator will begin flashing again.)
Contrast
Key
Each time this key is pressed, the unit will alternate between normal and dark
contrast modes (Normal/Dark).
Copy Key
This key causes the screen to be copied.
Multi-Copy/
Error
Indicator
This indicator displays the number of copies to be made. The display changes
each time the Multi-Copy/Stop Key is pressed.
Example: 1 → 2 → ··· → 9 → → 1 → ···
(Selecting “ ” allows you to copy 4 screens continuously.)
When an error occurred, a flashing symbol will appear in this display to
indicate the error status. (See page 27.)
Multi-Copy/
Stop Key
When making multiple copies or copying 4 screens continuously, press this
key until the desired number of copies or “ ” is displayed on the Multi-Copy/
Error Indicator. This key can also be pressed to stop copying while executing
multiple copies or copying 4 screens continuously.
• The display changes as shown below each time the screen is copied. After
reaching 0, the display will reset to 1.
Example for multiple copies
:
5 → 4 → 3 → 2 → 1 → 0 → 1 (Number is counted down.)
Example for copying 4 screens continuously
:
→ → → → 0 → 1 (Display changes.)
Advance
Key
Pressing this key advances the screen from right to left.
Pressing this key twice advances two screens from right to left.
Pressing this key more than 2 seconds advances the screen to the projector
screen with no ruled lines.
Reverse
Key
Pressing this key advances the screen from left to right.
Pressing this key twice advances two screens from left to right.
Pressing this key more than 2 seconds advances the screen to the projector
screen with no ruled lines.
Contrast/Remaining Film
Indicator
Reverse Key
Multi-Copy/Error Indicator
Multi-Copy/Stop Key
Advance Key
Contrast Key
Copy Key