Filter
Top Products
15
Introduction and Installation
To attach the AC adaptor and the DC terminal to a wall
By placing the AC adaptor and the DC terminal in the case and mounting the case
to the wall, you can protect the AC adaptor and the DC terminal from tampering and
exposure.
1 Attach the rear part of the case to a wall using the wood screws (4 mm x 16 mm,
3
/
16
″ x
5
/
8
″).
Note:
• Disconnect the DC cord from the clamp on the rear of the DC terminal beforehand.
See step 9 on page 14 for details.
• Take out the cardboard and wood screws from the AC case beforehand.
Wood screws
Case
83.5 mm
(
3
5
/
16
″)
Wall
2 Pack the AC adaptor and DC terminal as shown.
Pack the AC adaptor in the rear case.
• Be sure to run the power cord through the power cord hole.
Pack the DC cord in the rear case.
• Be sure to bundle the DC cord so that it will not touch the bottom of the
case.
Pack the DC terminal in the rear case.
• Be sure to run the wires through the wire hole, then under the wire rib.
Wire rib
Wire hole
DC terminal
Power cord hole
Power cord
AC adaptor
DC cord
3 Attach the front of the case.