Filter
Top Products
-8-
CONNECTIONS
Power Cable
1. Keep the camera Power switched OFF during
installation.
2. Connect the Power Cord (16) to a 60 Hz grounded
electrical outlet 120V AC .
Video Cable
1. Use the RG-59/U (3C-2V), RG-6/U (5C-2V). RG-
11/U (7C-2V) or RG-15/U (10C-2V) coaxial cable.
2. Up to 10 monitors can be hooked up in this config-
uration before signal loss occurs. Total cable
length should not exceed 500 feet (150m).
3. Wiring Precautions
• Do not bend coaxial cable into a curve whose
radius is smaller than 10 times of its diameter.
• Never crush or pinch the cable
All these will change the impedance of the cable
and cause poor picture quality
Cable RG-59/U RG-6U RG-11/U RG-15/U
(3C-2V) (5C-2V) (7C-2V) (10C-2V)
Recommended (ft) 1650 2475 3300 4125
maximum
cable length (m) 500 750 1000 1250
Recommended maximum cable length
External Sync
When a non-composite video signal is connected to
the monitor, it will be necessary to connect an external
composite sync signal to the monitor.
1. Connect the Sync Input Connector (14) on the
video monitor to the sync signal source by means
of a 75Ω coaxial cable.
2. Set the Sync Selector Switch (13) at EXT position.
NOTE:
1. Non-composite video signal is a signal without
sync.
2. External sync should be composed of mixed H.
Sync and V. sync signals, not H. and V. drive
pulse signals. Composite Sync Level:
4.0 Vp-p (2.0 Vp-p − 5.0 Vp-p)