Filter
Top Products
INSTALLATION INSTRUCTIONS PN433
*MTP is a registered trademark of US Conec Ltd.
For Instructions in Local Languages
and Technical Support:
www.panduit.com/resources/install_maintain.asp
www.panduit.com
E-mail:
cs@panduit.com
Fax:
(708) 444-6993
Page 4 of 4
FMTPRR6 - Replacing FMTPFCT and FMTPMFCT Cleaning Reel
1. The cleaning reel should only be replaced in a clean and dust free environment. A contaminated cleaning reel may
cause damage to fibers.
2. Use a coin or
screwdriver to
loosen the screw
located on the front
of the FMTPFCT or
FMTPMFCT Fiber
Cleaning Tools.
3. Open and remove
the cover using the
finger grip on the
side of the tool.
4. Remove the
cleaning reel and
winding reel by
lifting them straight
out of the tool.
Remove the
cleaning tape from
the winding reel.
Do not discard the
blue winding reel.
5. Place the empty
winding reel next to
the new cleaning
reel as shown.
Detach the
adhesive tape from
the cleaning reel
and attach to the
winding reel.
6. Place the winding
reel and the
cleaning reel into
the tool and route
the cleaning tape as
shown on the
diagram located on
the tool cover.
7. Hook the cover on
the tool body and
swing the cover
closed. Tighten the
screw.
8. Depress the green lever a few times and verify that the cleaning tape is advancing properly.
Windin
g
Reel
Cleanin
g
Reel
Hooks