Filter
Top Products
1. Network Management Specification
74 June 2003 8000-A2-GB30-00
7.6.1.2 pdnMgmtIpAddress (RW).
The IP address assigned to this port. If the pdnMgmtIpConfigMode is set to modes other
than ’manual’, then the MAX-ACCESS for this object is read-only and the value of the
object represents the actual IP address assigned to the port by the DHCP client (or 0.0.0.0,
if none assigned). Changes to this object could disrupt data flow through the port.
7.6.1.3 pdnMgmtIpNetMask (RW).
The IP subnet mask assigned to this port.
The MAX-ACCESS for this object behaves the same as the pdnMgmtIpAddress explained
above. Changes to this object could disrupt data flow through the port.
7.6.1.4 pdnMgmtIpEthGateway (RW).
The IP Gateway for an ethernet based IP port.
This object is supported only on IP ports that are configured to run over ethernet type of
media. This object would be set to 0.0.0.0 for other types of interfaces and is not valid.
7.6.1.5 pdnMgmtIpPhysAddress (RW).
The physical address associated with the media.
For IP Ports with Ethernet type of media, the MAX-ACCESS for this object is restricted to
read-only. In such cases, this object would reflect the MAC address of the underlying
ethernet data link. For IP Ports that run over ATM PVCs, this object is writable.
7.6.1.6 pdnMgmtIpConfigMode (RW).
The IP configuration mode for the port. The possible values are: manual(1), dhcp(2).
In “manual” mode, it is up to the user to provide the IP address and IP subnet mask of the
port.
In “dhcp” mode, the respective protocols are resposible to obtain and populate the IP
address and IP subnet mask for the port. The default value for all the interfaces is dhcp(2).
Whenever the config mode is changed from “manual” mode, the IP address and the IP
subnet mask for the port would automatically be reset to 0.0.0.0. External Manager stations
SHOULD NOT attempt to write the IP address or the IP subnet mask of the port when this
object is not in “manual” mode.
7.6.1.7 pdnMgmtBootIfIndex (RW)
The interface index of the ATM interface to be used by the DHCP client, if the
pdnMgmtIpConfigMode is set to “dhcp” respectively. For the Ethernet’s IP port, this object
is 0.
7.6.1.8 pdnMgmtBootVpi (RW)
The VPI of the ATM PVC to be used by the DHCP client, if the pdnMgmtIpConfigMode is
set to “dhcp” respectively.
7.6.1.9 pdnMgmtBootVci (RW)
The VCI of the ATM PVC to be used by the DHCP client, if the pdnMgmtIpConfigMode
is set to “dhcp” respectively.
7.6.1.10 pdnMgmtIpAdminStatus (RW)
The status of the IP Port (interface). Possible values are up(1), down(2).