Patton electronic 1089/I Network Card User Manual


 
AAPPPPEENNDDIIXX AA
PPAATTTTOONN EELLEECCTTRROONNIICCSS MMOODDEELL 11008899
SSPPEECCIIFFIICCAATTIIOONNSS
Clocking Modes: Internal or Receive Recovered
DTE Rate: 64, 128, 192, 256, 320, 384,448, 512, 576,
640, 704, 768, 832, 896, 960, 1024, 1088,
and 1152 kbps
Line Rates (DSL line): 144, 272, 400, 528, 784, 1168 kbps
Transmission Line: Single Twisted Pair
Line Coding: 2B1Q
Line Interface: Transformer coupled, 1500 VAC isolation
Diagnostics: V52 compliant (511/511E) pattern generator
and detector with error injection mode and
Remote Loopback control by a single front
panel switch
LED Status: The following LEDs are displayed on the
front panel:
DSL Link (Green Active) - DSL Link Active
10BT Link (Green Active) - Valid Ethernet
Connection
Status (Flashing Yellow) - Status indica-
tion from the Ethernet port
NS (Red Active) - No signal on DSP Link
ER (Flashing Red) - CRC error during nor-
mal operation, bit error during pattern gen-
eration test
TM (Active Yellow) - Test Mode Enabled
Configuration: Externally accessible dip switches or SNMP
managed through 1094ARC
Power: External desk top transformer, 100-240VAC,
50-60 Hz (Universal Input), 10W or -48
VDC
Compliance: FCC Part 15, CE, CTR1
Ethernet Specific
Connection: RJ-45, 10Base-T 802.3 Ethernet
Address Aging: Entries are deleted after 8 minutes of inac-
tivity
Frame Latency: 1 Frame
Frame Buffer: 512 Frames
Ethernet Physical
Connection:
pin 1 Tx Data +
pin 2 Tx Data -
pin 3 Rx Data +
pin 6 Rx Data +
pins 4, 5, 7, 8 no connection
19
AAPPPPEENNDDIIXX BB
PPAATTTTOONN EELLEECCTTRROONNIICCSS MMOODDEELL 11008899
FFAACCTTOORRYY RREEPPLLAACCEEMMEENNTT PPAARRTTSS
AANNDD AACCCCEESSSSOORRIIEESS
Patton Electronics Model #
Description
1089/I ..............................10BaseT HDSL Rocket (CAP)
080551 ............................120V Power Supply
080552 ............................230V Power Supply
48V-PSM.........................DC Power Supply Module
08055DCUI .....................100-240VAC (+5V ±5% reg. DC/2A)
Universal Input Adapter
0805EUR ........................European Power Cord CEE 7 (“A”)
0805UK ...........................United Kingdom Power Cord (“D”)
0805US ...........................American Power Cord (“K”)
0805AUS.........................Australia/New Zealand Power Cord (“C”)
0805DEN.........................Denmark Power Cord (“E”)
0805FR............................France/Belgium Power Cord (“F”)
0805IN.............................India Power Cord (“G”)
0805IS.............................Israel Power Cord (“H”)
0805JAP..........................Japan Power Cord (“J”)
0805SW...........................Switzerland Power Cord (“L”)
07M1089/I .......................User Manual
20