Filter
Top Products
14
4.2 CONFIGURING DIP SWITCH S1
DIP switch S1 is where you configure the CopperLINK line. The following
tables describe the configuration for the 2151.
5.0 OPERATION
Once the Model 2151s are properly installed, they should operate trans-
parently. No user settings required. This section describes reading the
LED status monitors.
5.1 POWER UP
Before applying power to the Model 2151, please review section 3.3,
“Connecting Power” on page 12 to verify that the unit is connected to the
appropriate power source.
Table 1: 2151 Firmware Configuration
Position
S1-1 S1-2 S1-3 S1-4
Master/
Slave
Rate
ON Slave
(CPE)
4/1, 9/1, 16/2, 6/6, 10/10, 15/15
Rate Control (See table below).
OFF Master
(CO)
S1-2 S1-3 S1-4
Rate
(DS/US)
*
*. DS = Downstream, US = Upstream
OFF OFF OFF 4/1
ON OFF OFF 9/1
OFF ON OFF 16/2
ON ON OFF 6/6
OFF OFF ON 10/10
ON ON ON 15/15