Filter
Top Products
2 Model 3202 Quick Start Guide
1.0 Connect the power and ports
1. Connect the power adapter to the port labeled DC 9V on the rear panel of the Model 3202.
2. Connect the Ethernet cable to the MGMT port.
Note The Model 3202 supports auto-MDX/MDIX switching hub so you may use a straight-through or cross-
over Ethernet cable.
3. Connect the phone cable to the Model 3202 and the other side of phone cable to wall jack.
4. Connect the power adapter to power source.
5. Turn on the PC to configure the Model 3202.
• The Model 3202 contains no user serviceable parts. The equip-
ment shall be returned to Patton Electronics for repairs, or
repaired by qualified service personnel. Opening the Model
3202 case will void the warranty.
• Mains Voltage: Do not open the case the when the power cord
is attached. Line voltages are present within the power supply
when the power cords are connected. The mains outlet that is
utilized to power the device shall be within 10 feet (3 meters)
of the device, shall be easily accessible, and protected by a cir-
cuit breaker.
• For AC powered units, ensure that the power cable used meets
all applicable standards for the country in which it is to be
installed, and that it is connected to a wall outlet which has
earth ground.
• Hazardous network voltages are present in WAN ports
regardless of whether power to the Model 3202 is ON or OFF.
To avoid electric shock, use caution when near WAN ports.
When detaching the cables, detach the end away from the
Model 3202 first.
•
Do not work on the system or connect or disconnect cables dur-
ing periods of lightning activity.
To avoid possible damage to this Model 3202, do not turn on the modem
before connecting the cables.
WARNING
WARNING