Filter
Top Products
6 EHA3201 Quick Start Guide
Note It does not matter whether the positive (+) or negative (-) side of the DC power supply is grounded.
However, the polarity on the power source must be matched up properly to the EHA3201 power input
(i.e. negative power source terminal to negative power input; positive power source terminal to positive
power input).
2.0 Configuring the EHA3201
The EnviroNET G.SHDSL Router comes pre-configured to communicate with other devices on the network. To
futher configure the EHA3201, you may log into the web management system.
2.1 Connect to a PC
1. Connect the EHA3201’s Data port to your PC (see figure 5).
2. The PC used for configuring the EHA3201 should be set for DHCP client.
3. Connect the EHA3201 to a power source to turn on the unit.
4. The EHA3201 Data port uses the DHCP client to automatically assign an IP address and netmask. The
EHA3201 will send the IP address to the PC.
5. Enter the EHA3201’s IP address in the address bar of the web browser.
6. Log in and perform any desired configuration changes through the EHA3201’s web browser interface.
Figure 5. Connecting the EHA3201 to the local IP network
For information on changing the IP address, refer to Chapter 3 “Quick Start Installation” in the Model 3201 &
3241 User Manual.
Connect to
Ethernet port
(
DATA
)
Ethernet port
PC
E
n
viro
N
E
T
ª
P
O
W
E
R
D
A
T
A
L
I
N
E