Filter
Top Products
OPERATION
1
Squeeze operating lever completely.
2
Release operating lever completely.
3
Apply label to item being marked as shown.
n
A wiping motion works best, DO NOT POUND
labeler when applying labels.
REMOVING SUPPLIES
1
Tear label strip and carefully remove label roll.
2
Squeeze and release operating lever until
backing paper exits here.
MAINTENANCE
1
If labeler has no label guide:
Remove label roll. Squeeze
operating lever half way and feed label
removal strip under brake wheels...
If labeler has label guide:
Remove label roll. Squeeze
operating lever half way and feed
label removal strip over label guide,
under brake wheels...
2
To clear backing paper
track, insert label removal
strip here, using corner to
remove stray labels.
3
Squeeze operating lever to turn feedwheel
for inspection. Remove stray labels with corner
of label removal strip.
4
Remove ink door and inspect door opening for
stray labels. Remove stray labels with corner of
label removal strip.
OPERATION, REMOVING SUPPLIES & MAINTENANCE
LUBRICATION TROUBLESHOOTING
Monarch Lubricant 086989 is recommended.
Lubricate as shown below with labeler loaded
when:
a. slow or hesitant feeding occurs.
b. adhesive buildup is seen.
c. feedwheel tears backing paper.
d. ink roll is changed.
If none of the above eliminates the problem, return
labeler to an Authorized Paxar Service Center.
PRINT LOCATION ADJUSTMENT AVAILABLE SUPPLIES
Print location is correct when
all characters are fully visible on
the printed label. Dial characters
for every position when testing
location.
1
Place small coin in slot of each
disk (one on each side of labeler)
as shown.
2
Hold coin steady in slot labeled
HOLD, and turn other coin very
slowly clockwise until one click is heard.
3
Print sample label and check for
correct print location.
4
Repeat steps 1, 2, and 3 until print
is correctly located. If correct print
location is passed, continue adjustment
until correct print location reappears.
Rollers
Label
Guide
and out the front of labeler.
Feedwheel
Problem Solution
Labels will not
feed.
Reload per instructions.
Check for correct supplies.
Follow MAINTENANCE
instructions.
Check for correct print location.
Print incorrectly
located.
Adjust per PRINT LOCATION
ADJUSTMENT instructions.
Printing smeared
or distorted.
Print several labels (15-20) until
excess ink is used up.
Printing too light
(all over).
Install new ink roll per INKING
instructions.
Squeeze operating lever harder
during operation.
Slow hesitant
feeding. Labeler
tends to ‘hang up’
when operating
lever is released.
Follow MAINTENANCE
instructions.
Lubricate per instructions.
LUBRICATION, TROUBLESHOOTING & PRINT LOCATION
Visit www.paxar.com for sales, service, supplies, information,
and telephone numbers of our locations throughout the world.
TOLL FREE:
1-800-543-6650 (In the U.S.A.)
1-800-363-7525 (In Canada)
Tear
and out the front of labeler.
Insert label removal strip here
to loosen labels.
LUBRICATE:
One drop
each side of
label chute.
LUBRICATE:
One drop each spot on
backing paper. Spread
with finger.
DO
NOT OVER
LUBRICATE!
Warranties
PRODUCT WARRANTY STATEMENTS MAY
VARY FROM COUNTRY TO COUNTRY.
PLEASE CONTACT THE AUTHORIZED PAXAR
REPRESENTATIVE IN YOUR COUNTRY
FOR DETAILS.
000940 Holster (Vinyl)
000935 Label Scraper
(w/ handle, Pkg of 20)
M00PLS01 Label Scraper
(w/o handle Pkg of 10)
119919 Maintenance Kit
08394601 Black Ink Roll