Filter
Top Products
4.
Figure 13 shows the burster with the supplies installed.
Place the separator bars in their approximate working
positions (i.e. in line with the perforations). When only one
bar is needed (for two part supply), slide unused bar to the
outboard side.
5.
Thread the inner strip of supplies under the dancer arm
roller, behind the two lower burster shafts, and in front of
the top shaft.
6.
Thread the middle strip under the dancer arm roller,
behind the lower burster shaft, and in front of the two top
shafts.
7.
Thread the outer strip under the dancer arm roller, behind
the two lower burster shafts, and in front of the top shaft.
Separator
Bars
Figure 13
Monarch 415 Rewind Operator’s Handbook
12