Filter
Top Products
3
R
S
2
3
2 P
o
rt
“T” Lever
Su
pp
l
y
Door
Connecting the Printer
1. Plug your host into the printer’s RS232
port using a modular connector.
2. Turn on the printer.
3. Make sure the DIP switches are set to
match the communication
values on your host.
Loading Supplies
The printer can print text, bar codes,
and some limited graphics on thermal
direct receipt paper.
1. Lift up the “T” lever on the supply
door and wrap your fingers around
it.
2. Pull up firmly on the supply door to
open it.
3. Drop the supply into the
well. Make sure the supply
unwinds from the bottom.
4. Position the supply between
the printhead guides.
5. Make sure 2-3 inches of supply extends past the printhead.
6. Close the supply door.
Tearing Supply
The printer’s supply door acts as a
tear bar. Tear down against the tear
bar to remove receipts.
Do not tear supply up against the
printhead or sideways, because
the supply door may open.
Tear Bar