Filter
Top Products
Setting Up the Printer 3-9
Adjusting the Print Position
Use this option to adjust where data prints vertically on the supply. The
range is between -99 to 99. The default is 0. Adjust the print if it is too
close to the top or bottom of the supply, or overtypes a pre-printed area.
1. From the Printer menu, select Print Pos.
Print Position
+00
↵ f +
Use A as shown in the following table:
↵
f
+
Press A to
Press A to Press A to
Enter
Save the setting
Set the position (+00)
1
st
position
2
nd
position
3
rd
position
Toggle between
positive and negative
Increase the setting
by 10
Increase the setting by 1
2. When the setting you want is displayed, press A under ↵ to save the
setting.
You return to the Printer menu.