Filter
Top Products
SP / TC / GT
PAGE 5
CENTURY SERIES
Designed & manufactured in the USA by:
A division of Crest Audio Inc.
100 Eisenhower Dr.
Paramus, New Jersey 07652 USA
POWER OUT
POWER OUT
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION
AVIS : RISQUE DE CHOC ÉLECTRIQUE—NE PAS OUVRIR
WARNING TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK DO NOT
EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE.
ATTENTION! POUR ÉVITER LE RISQUE D'INCENDIE OU DE CHOC
ÉLECTRIQUE, NE PLACEZ PAS CET APPAREIL SOUS LA PLUIE OU Á
L'HUMIDITÉ
6
7
2
1
4
5
3
Pin1 +24V
Pin2 +20V
Pin3 Analog
Pin4 Analog
Pin5Digital
Pin6 +48V
Pin7 -20V
CONSOLE
GROUND
CHASSIS
GROUND
MAXIMUM AC IN:
XCVA04: 415 WATTS
XCVA06: 825 WATTS
+ 48V@ 1
+ 24V@ 6
± 20V@ 6
ModelXCVA06
ModelXCVA04
± 20V@ 4
+ 24V@ 4
S/N
Designed & manufactured in the USA by:
A division of Crest Audio Inc.
100 Eisenhower Dr.
Paramus, New Jersey 07652 USA
POWER OUT
POWER OUT
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION
AVIS : RISQUE DE CHOC ÉLECTRIQUE—NE PAS OUVRIR
WARNING TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK DO NOT
EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE.
ATTENTION! POUR ÉVITER LE RISQUE D'INCENDIE OU DE CHOC
ÉLECTRIQUE, NE PLACEZ PAS CET APPAREIL SOUS LA PLUIE OU Á
L'HUMIDITÉ
6
7
2
1
4
5
3
Pin1 +24V
Pin2 +20V
Pin3 Analog
Pin4 Analog
Pin5Digital
Pin6 +48V
Pin7 -20V
CONSOLE
GROUND
CHASSIS
GROUND
MAXIMUM AC IN:
XCVA04: 415 WATTS
XCVA06: 825 WATTS
+ 48V@ 1
+ 24V@ 6
± 20V@ 6
ModelXCVA06
ModelXCVA04
± 20V@ 4
+ 24V@ 4
S/N
To AC Mains
To AC Mains
Interface Cable
To Console
Power Connections
The connections to and from the power supply vary depending
on your specific configuration. Before setting up the console,
always check to make sure the AC voltage marked on the
power supply agrees with the local supply. Always connect the
console to the power supply before switching on the power
supply. Do not run the power supply if it is not connected to
the console.
Multiple power supplies can be daisy-chained to provide fail-
safe protection in the event of a supply failure. When two or
more supplies are used, both power supplies run all the time. In
the event of supply failure, the remaining power supply(s) will
take over the entire load.
NOTE: Although both of the multi-pin connectors on the back
of the power supply are labeled “POWER OUT”, it is neces-
sary (and acceptable) to link two power supplies together as
shown in the diagram below.
ADDITIONAL NOTE: The multi-conductor cable used for
power supply-to-power supply connection is different than that
used for a conventional power supply-to-console connection,
and must be specified when the second power supply is
ordered.
Ground Link