Filter
Top Products
11 of 11
ISSUED: 1-11-08 SHEET #: 055-9495-2 10-16-08
Visit the Peerless Web Site at www.peerlessmounts.com
For customer care call 1-800-865-2112 or 708-865-8870.
For PRG swivel adjustment: Loosen two screws indicated in figure 9.1 half a turn using allen wrench (P) to allow
for adjusting swivel. Align projector to the desired swivel position and fully tighten screws indicated.
For PRS swivel adjustment: Loosen two screws indicated in figure 9.1 half a turn using allen wrench (P) to allow
for adjusting swivel. Align projector to the desired swivel position and fully tighten screws indicated.
To adjust tilt and roll, refer to instruction included with projector mount.
Projector Alignment
9
20° (±10°) SWIVEL
• Do not loosen adjustment screws to the point they become disengaged from the mount. Weight of the projector should
be supported in case of accidental disengagement.
WARNING
SWIVEL ADJUSTMENT
TOP VIEW
© 2008, Peerless Industries, Inc. All rights reserved.
All other brand and product names are trademarks or registered trademarks of their respective owners.
SCREWS FOR SWIVEL
ADJUSTMENT
SWIVEL ADJUSTMENT WITH PRG
fig. 9.1
SWIVEL ADJUSTMENT WITH PRS
fig. 9.2
SCREWS FOR SWIVEL
ADJUSTMENT