Filter
Top Products
2 Pelco Manual C524M (8/97)
2.0 DESCRIPTION The CM6700-VMC2 is a 2-monitor expansion card for the CM6700 Matrix System.
This simple, plug-and-play installation expands the CM6700 video outputs from
two (2) to four (4) monitors. When the system is powered again after installation,
the CM6700 will automatically recognize the expansion card.
Included in this package:
Qty Item Part Number
1 2-monitor expansion card CM6700-VMC2 (NTSC version)
CM6700-VMC2-X (PAL version)
5 1/4-inch hex standoff SPA8423
5 6-32 phillips head screw ZH6-32.250BPP
5 #6 nylon washer ZH150X310X32N
3.0 INSTALLATION To facilitate the installation the CM6700-VMC2 expansion board, removal of the
CM6700 Switcher/Controller Unit (SCU) from its installed location may be required.
Inspect the expansion card prior to installation. It is very important that all of the
expansion card connector pins are straight before attempting to install the expan-
sion card.
To install the CM6700-VMC2 do the following:
1. Disconnect the CM6700 power cord from the wall outlet.
2. Remove the top cover from the CM6700 SCU.
3. Remove and replace the five (5) motherboard mounting bolts with the five (5)
1/4-inch hex standoffs (supplied), and tighten. See Figure 1.
4. Determine the correct orientation of the expansion card to the motherboard.
The connector pins on the expansion card correspond to the 8 connectors
shown in Figure 1.
5. Seat the expansion card. This is a delicate process. The connector pins on the
expansion card must align exactly with the connectors on the motherboard.
a. Place the expansion card onto the standoffs.
b. Align the two (2) connector pins indicated in Figure 1 with their corre-
sponding connector openings.
c. Once the pins are aligned, gently push the expansion card onto the con-
nectors, a little at a time, until the expansion card is completely seated
onto the motherboard.
d. Be sure that the expansion board is fully seated.
8. Using the 6-32 screws and nylon washers (included), secure the expansion
card to the standoffs.
9. Replace the SCU cover and plug the power cord into the wall outlet.
The SCU will automatically recognize the expansion card upon power up of the
system.
IMPORTANT:
The expansion card
must be carefully aligned to avoid
damage to the connector pins.
CAUTION:
The CM6700-
VMC2 is a static sensitive
device. Exercise caution
during handling and while
working around the exposed
electronics within the
CM6700.
WARNING:
Installation of
the CM6700-VMC2 should
only be done by qualified
service personnel and
should include the use of an
appropriate grounding
strap.