Filter
Top Products
C1501M-A (3/05) 5
Installation Instructions for CM9700-CC1-VID
1. Turn off all power to the CC1. Disconnect and label all attached cabling.
2. Install the VGA card in the CC1. Refer to Figures 1 and 2 and do the following:
a. Loosen and remove the top cover mounting screws.
b. From the rear, tilt the top cover up at a slight angle, and then pull backwards away from
the front edge to remove it from the CC1 chassis.
c. Remove the retaining screw of the existing graphics card. Gently pull the card straight
up. If there is no existing card, remove the retaining screw for the slot cover of any
vacant PCI expansion slot. Slide the cover out.
d. Install the new VGA card into the selected PCI expansion slot from step c. Carefully align
the gold-fingered edge connector of the VGA card with the PCI slot. Gently but firmly
press the VGA card down until fully seated into the PCI slot. Reinstall the retaining
screw to secure the VGA card into place.
e. Reinstall the top cover and secure with mounting screws.
Figure 1.
Removing the CC1 Top Cover
WARNINGS:
•
Failure to turn off the CC1 power could result in serious damage to the equipment.
•
Electrostatic Discharge (ESD) precautions must be observed when performing the
procedures described in this manual. Always wear a gounding strap connected to an
approved grounding source when working on or around exposed electronic components.
C1501M-A-002
C1501M-A.book Page 5 Wednesday, April 6, 2005 8:08 AM