Filter
Top Products
6
English
Set the POWER slider to the desired sound source:
CD, TAPE, or BAND (for radio).
The set is switched off when the POWER slider is set to OOFFFF/TAPE
and the keys of the tape deck are released.
Note: If you use batteries, switch the set off after use. This will
avoid unnecessary power consumption.
Adjust the volume using the VOLUME control.
Increase and decrease the bass level by pressing DBB.
The bass level can also be emphasised if you place the set against
wall or shelf. Do not cover any vents; leave sufficient room around
the unit for ventilation.
1 Set the POWER slider to FM or MW to select the desired
wave band.
2 Tune to the desired radio station by using the TUNING wheel.
Improving RADIO reception
For FM stations, pull out the telescopic antenna. To improve the
signal, incline and turn the antenna. Reduce its length if the signal
is too strong (very close to a transmitter).
For MW stations, direct the built-in antenna by turning the whole
set. The telescopic antenna is not needed.
OPEN
FM AM
1700
1300
1000
800
630
100
98
97
104
108
HRO START RECORDING
Radio – tuning to radio stations
POWER
DBB
DYNAMIC
BASS
BOOST
VOLUME
CD SYNCHRO STA
R
Adjusting volume and sound
OFF
BAND
TAPE
CD
FM
AM
POWER
DBB
DYNAMIC
BASS
BOOST
CD SYNCHRO STA
R
Switching the set on and off
BASIC FUNCTIONS RADIO