Filter
Top Products
User Manual BDL4635E
17
Install the LCD Monitor
in
P
ortrait
M
ode
BDL4635E
can
be
installed
in
portrait
position,
under
the
following
conditions:
Caution:
Portrait
mode
is
ef
fective
only when
wall-mounted
or
ceiling-mounted.
The
Table stand
can
not
be
used for
the
monitor
in
portrait
position.
Placing
the
monitor
in
portrait
position,
will
shorten
the
average
life
of
the
LCD
backlight.
Operational
Envir
onment
(T
emperatur
e)
shall
be
limited,
as
shown
below:
Operational
Envir
onment
T
e
mperatu
r
e
5
-
35 °C
/
41
-
95
°F
Humidity
20
-
80
%
(without
condensation)
Please
orientate
the
monitor
in
the
direction
shown
as the right figure:
Do
not
place
monitor
in
landscape
in
any
other
manner
.
How
to
set-up
1.
Remove
the
Table stand if they are attached.
2.
The
“ ”
logo
should
be
on
the
LEFT
side when
facing
the
monitor
.
How to Remove the Logo for landscape mode?
1. Prepare a piece of paper with a cutting area of logo as a protector to
prevent the front bezel from scratching.
2. Using an knife, carefully remove the logo sticker with the paper placing
beneath.
3. Tear off the logo sticker.
How to Use the Logo Guider for Portrait Mode?
1. Before applying, make sure the guider is well shaped. The "PHILIPS"
sticker attached on the end of it could be folded back as figure a.
2. Turn back the logo end of the guider and remove the sticky tape of the
logo.
3. Slide the logo guider along the short side of the front bezel as figure c &
then re-turn the logo end of the guider back to the right side.
4. With your left hand fixing the guider, scrunch the logo by your right hand
to make it stuck firmly on the front bezel.
5. Remove the guider and leave the logo over the front bezel.
Clockwise
Counte
r
clockwise