Filter
Top Products
Gates Underwater Products
• 5111 Santa Fe Street, Suite H • San Diego, CA • 92109
858.272.2501 • 800.875.1052 • Fax 858.272.1208 • www.GatesHousings.com
7
Monitor Adjustment
The EM43 has three adjustments for hue, contrast and brightness. These adjustments
can be found on the inside rear half of the housing (see photo).
While the monitor is pre-adjusted at the factory, Gates recommends the monitor be
further adjusted to match the camera being used. This will ensure a consistent match
between the monitor and the image actually being recorded.
Matching the camera and monitor should be done in a darkened area to allow good
viewing of both the monitor and the camera electronic viewfinder (EVF).
With the camera on and the monitor plugged in, compare the image on the EVF to the
monitor. Using a small Philips screwdriver, make minor adjustment to the hue, contrast
and brightness on the EM43 until you are satisfied that the image on the monitor
accurately reflects that being seen in the EVF.
NOTE: Hue adjustment is only applicable to NTSC SD input mode. It is not used in PAL
SD or HD input modes.
Customer Support
If you have any questions or require further assistance with your EM43 External Color
Monitor, contact your dealer or Gates directly and we’ll be happy to assist.
Email: Customer.Srvc@GatesHousings.com
Phone: 858-272-2501
Fax: 858-272-1208
Brightness
Contrast
Hue