Filter
Top Products
20
Turning On / Off the Projector
7. Operation
Turning On the Projector
Connect the projector's AC power cord into an AC outlet. The
Power Indicator lights red(dim), and the Standby Indicator
lights green.
2
3
Turning Off the Projector
Press Standby/On button on the top control or off button on
the remote control. The message "Power off?" appears on the
screen.
Press Standby/On button on the top control or off button on
the remote control again to turn off the projector. The Power
Indicator turns bright red and the Standby Indicator turns off.
The cooling fans remain running for 90 seconds after the
projector is turned off. During this "Cooling Down" period, the
projector cannot be turned on.
1
2
To maintain the lamp-life, once you turn on the projector,
wait at least 5 minutes before turning it off.
Tu r ning On / Off the Projector
1
Complete peripheral connections (with a computer, VCR, etc.)
before turning on the projector. (Refer to "Installation" on page
15~16)
3
When the projector has been cooled down, the Standby
Indicator lights on again and you can turn on the projector.
Then AC power cord can be disconnected if necessary.
Message disappears after 4 seconds.
When “Power management” function is ON, the projector turns off its lamp when the signal is interrupted and no button is
pressed for a certain period. Refer to “Power management” on page 37.
Note : When “On start” function is ON, this projector is
turned on automatically when connecting the AC
power cord to an AC outlet. (Refer to page 37.)
Press Standby/On button on the top control or on button on
the remote control. The Power Indicator dims, and the
cooling fans start to rotate. Preparation Display appears on the
screen and count-down starts. The signal from a PC or video
source comes up after 30 seconds.
Current Input position and Lamp mode status are also
displayed on the screen for 5 seconds. (Refer to "Lamp mode"
on page 37.)
Preparation Display disappears after 30 seconds.
Input position and Lamp mode status
When the Temperature Warning Indicator flashes red, the projector will automatically shut itself off. Wait at least 5 minutes,
and confirm if the Standby Indicator will light on and the projector can be turned on by pressing the Standby/On button.
If the Temperature Warning Indicator continues to flash, refer to the section "Maintenance" on page 39 to take a proper
maintenance.