Filter
Top Products
13
Chapter 2 How to Use the Navigation System and Names of the Parts
r To cancel standby mode, press the V button
again, or touch the screen.
When Using the Navigation Sys-
tem for the First Time
The navigation system cannot detect the location
correctly if the initial learning is not complete.
The correct positioning can be attained after driv-
ing a certain distance. (The AV source can be
used normally regardless of the initial learning
status.)
When the vehicle starts to run, the 3D Hybrid
Sensor’s initial learning automatically starts.
Until the 3D Hybrid Sensor’s initial learning is
complete, the positioning is performed by GPS
satellites so the location of your vehicle may not
be very accurate. This is not an error. When the
initial learning is complete, the location of your
vehicle can be detected with high accuracy.
r When an error message appears during the
initial learning, refer to “Messages and How to
React to Them” in the operation manual.
Selecting a Source with the AV
button
1 Turn the ignition switch (ACC) ON.
The navigation system’s power supply comes
on.
2 After the navigation system starts, press
the AV button to switch the screen.
The navigation map screen changes to the
audio source screen.
3 Press the AV button to turn the audio
source on.
4 Press the AV button to select a source.
Press the AV button repeatedly to switch
between the following sources:
[CD/ROM (MP3)/DVD] (built-in DVD drive)
— [LIBRARY] (HDD player) — [FM] (FM
tuner) — [AM] (AM tuner) — [XM] (XM tuner)
— [SIRIUS] (SIRIUS tuner) — [iPod] (iPod)
— [M-CD] (multi-CD) — [TV] (television) —
[AV INPUT] (video input) — [AUX] (auxiliary
equipment) — [EXT 1] (external unit 1) —
[EXT 2] (external unit 2)
r Press and hold the AV button to turn the
source off.
r In the following cases, the sound source can-
not be used:
— When a unit corresponding to the source is
not connected to the navigation system.
— When no disc is set in the navigation sys-
tem.
— When no magazine is set in the multi-CD
player.
— When [AUX Input] (auxiliary input) is
turned off (refer to operation manual).
— When [AV Input] (video input) is not set to
[Video] (refer to operation manual).
r “External unit” refers to a Pioneer product
(such as one available in the future) where,
although it is incompatible as a source, the
basic functions can be controlled by the navi-
gation system. Two external units can be con-
trolled by this navigation system. When two
external units are connected, the navigation
system allocates them to external unit 1 or
external unit 2.
r When the [Auto ANT] mode is set to
[Radio], the vehicle’s antenna can be stowed
or turned off by following one of the steps
below.
— Change the source from radio (AM or FM)
to another source.
— Turn the source off.
— Turn off the ignition switch (ACC OFF).
If the [Auto ANT] mode is set to [Power], the
vehicle’s antenna can be stowed or turned off
only when the ignition switch is turned off
(ACC OFF).
ò [Auto ANT] Þ operation manual
Adjusting the Volume
•Use the VOL (/) button to adjust the
audio sound level.
Press the VOL (/) button to increase or
decrease the volume.
r To adjust the navigation volume, go to the
navigation menu.
ò Navigation volume adjustment Þ opera-
tion manual