Filter
Top Products
TIB #190112
Pioneer Electronics (USA) Inc. Released: Aug-2007
To determine when to replace versus clean filters, refer to the following chart:
Clean The Filters Replace the Filters (Part # DEC2530)
9 grime on filter cover can be wiped away
9 visible dirt on the filter is removable with
a small vacuuming device
(available commercially)
9 cover or filter feels greasy to the touch
9 any dirt or debris remains after wiping the
cover or vacuuming the filter
The replacement filter (P/N DEC2530) is available from the Pioneer Electronic Service organization.
http://parts.pioneerelectronics.com
or call (800) 228-7221 for the Parts Department
The replacement part DEC2530 consists of a single filter. Replace both front filters at the same time
to keep the PRV-LX1 at top performance. Follow the directions below to replace a filter.
1. Confirm that the PRV-LX1 is in Standby (indicator light is orange).
If the PRV-LX1 is not in Standby, stop any current operation then press and hold the
STANDBY/ON button for at least two seconds to place the recorder in Standby.
2. Turn the main power off.
Set the rear power switch to OFF.
3. Disconnect the power plug from the outlet.
4. Slide a front filter cover down while pulling the bottom edge slightly away to remove it.
Do not discard this cover as it is reused.
Home & Business Group of America
(800) 872-4159
Page 3 of 5