Filter
Top Products
57
When TV SYSTEM=AUTO
<VIDEO, Y/C Input)
• Selects the convergence memory from MEMORY-1 or MEMORY-2 automatically according to the signals input (NTSC/PAL).
<RGB Input>
• Automatically selects the convergence memory as follows.
For NTSC input:MEMORY 1
For PAL input:MEMORY 2
Horizontal frequency 20 kHz to 28 kHz input:MEMORY 3
Horizontal frequency 28 kHz to 35 kHz input :MEMORY 4
When TV SYSTEM=NTSC
• The convergence memory is always set to MEMORY 1 regardless of the input signal.
When TV SYSTEM=PAL
• The convergence memory is always set to MEMORY 2 regardless of the input signal.
In standard settings, MEMORIES 1 to 4 are selected as described above, but MEMORIES 5 to 7 can be selected if preset using
the remote control or commands of the Personal Computer.
When the input signal is NTSC only or PAL only, by setting the TV SYSTEM to NTSC or PAL, smooth input switching (no
image distortion) will be possible.
Normally, no problems will be encountered with the above method. But if two or more types of signals are input to the same
input function, convergence adjustment has to be performed according to the respective input source. (For example, when
there is signal phase difference in each input source, when connecting several PCs and switching from outside, etc.). In such
cases, use convergence adjustment memories 5 to 7 (MANUAL 1 to 3). The 5 to 7 convergence adjustment memories can be
switched from outside using the Personal Computer.
Finally, examples of main uses by the system of these units are provided below.
For details of how to set the convergence memory (specific example), refer to ”3. Examples of Main Uses of Cube System”.
ADJUSTMENTS