Filter
Top Products
ConnConn
ConnConn
Conn
ecting the displayecting the display
ecting the displayecting the display
ecting the display
(F(F
(F(F
(F
igure 1.1)igure 1.1)
igure 1.1)igure 1.1)
igure 1.1)
To configure this monitor, please refer to the following figure and procedures.
1. Be sure all equipment is off.
2. Connect the DC power cord to the power connector. Plug one end of the AC power
cord into the power adapter, and the other end into an electrical outlet
(1.1 1 ).
3. For the PC with Analog output: connect the VGA signal cable from display VGA
input connector to the 15-pin connector of your host computer and tighten the
screws (1.1 2 ).
4. Connect the USB cable from USB port of your display to the USB port of your
computer (1.1 3 ).
5. Turn on your computer, display and video source.
Notice:Notice:
Notice:Notice:
Notice: To ensure the LCD display works well with your computer, configure the
display mode of your graphic card, less than or equal to 1280 x 1024
resolution and make sure the timing of the display mode is compatible
with the LCD panel. "Video Modes" of this LCD panel are listed in the
appendix for your reference."
8