Filter
Top Products
1
FCC Information
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio frequency energy, and if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC Warning:
To assure continued FCC compliance, the user must use the provided grounded power supply cord and the
provided shielded video interface cable with bonded ferrite cores. Also, any unauthorized changes or
modifications to this TFT LCD would void the user's authority to operate this device.
Department of Industry Canada (IC) Compliance Notice
The digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus set out in
the Radio Interference Regulations of the Canadian Department of Communications.
SAFETY PRECAUTIONS
Caution: Use a power cable that is properly grounded. Always use the AC cords listed below for each
area:
USA .........................…….UL
Canada .............…………CSA
Germany ...........…………VDE
Switzerland ............……. .SEV
Britain ................…………BASEC/BS
Japan ..............………….. Electric Appliance Control Act
Use an AC cord in other areas that meets local safety standards.