Filter
Top Products
8
u
Connecting the Display
(Figure 9.1)
To setup this display, please refer to the following figure and procedures.
1. Be sure all equipment are off.
2. Connect the DC power cord to the power connector( The arrow sign é
must face down) ; plug one end of the AC power cord into the power
adapter, and then the other end into an electrical outlet().
3. For the PC with Analog output: Connect the VGA signal cable from
display VGA input connector to the 15-pin connector of your host
computer and tighten the screws().
4. Connect the Audio-In cable from audio input port of your display to the
Audio-out port of your computer().
5. Connect the RS-232 cable from RS-232 port ofyour display to the
RS-232 port of your computer().
6. Turn on your computer, display and video source.
Start Your Installation
Notice: To ensure the LCD display can work well with your computer,
please configure the display mode of your graphic card to make
it less than or equal to 1280 x 1024 resolution and make sure
timing of the display mode is compatible with the LCD display.
We have listed the Compatibility Modes of this LCD display in
appendices for your reference.