Filter
Top Products
14
4. TROUBLESHOOTING
This chapter contains information to help you solve issues. If the Switch
is not functioning properly, make sure the Gigabit Ethernet Switch was
set up according to instructions in this manual.
The per port LED is not lit
Solution:
Check the cable connection of the GSD-800.
Performance is bad
Solution:
Check the speed duplex mode of the partner device. The GSD-800 is
run at Auto-negotiation mode and if the partner is set to half duplex,
then the performance will be poor.
Per port LED is lit, but the trafc is irregular
Solution:
Check that the attached device is not set to dedicate full duplex. Some
devices use a physical or software switch to change duplex modes.
Auto-negotiation may not recognize this type of full-duplex setting.
Why the Switch doesn’t connect to the network
Solution:
Check per port LED on the Switch. Try another port on the Switch Make
sure the cable is installed properly Make sure the cable is the right type
Turn off the power. After a while, turn on power again.