Filter
Top Products
9
3. Powerline to Ethernet Converter Installation
1. Plug the other end of the UTP category 5 cable into the computer’s LAN port.
2. Plug the UTP category 5 cable into the 10/100 RJ45 Ethernet port on PL-101E.
3. Plug the power cord into the powerline port on PL-101E.
4. Plug the other end of the power cord into a power outlet.
Note!
Use only the supplied power cord to connect PL-101E to the power outlet.
Because PL-101E sends data over the powerline of your house, it is best to
plug PL-101E’s power cord directly into a power outlet. Do not plug PL-101E
into a UPS power strip with surge protection. PL-101E has its own power
filter for protection against surges.
All the Powerline devices must on the same electrical phase.