PLUS Vision U5-532 Projector User Manual


 
E-62
Troubleshooting
Check the following matters before requesting servicing.
Is the power cord plugged into a power outlet?
Is the lamp cover properly mounted?
Is the projectors temperature high? To protect the projector, the power can-
not be turned on when the projectors temperature is abnormally high.
Has the lamp reached the end of its service life?
Is a connected input selected?
Is the cable properly connected to the input terminal?
When a computer is connected, are signals being output from the computer?
Does the signal being input have a frequency usable with this projector?
Are the brightness and contrast adjusted to the minimum?
Is the STATUS indicator lit a steady red or flashing red?
When the component signal of the DVD player is connected with the RGB
connector and the image is not output, is [Input Settings] of the RGB con-
nector properly selected?
For a RGB input, has the picture been properly adjusted?
Is the projector properly installed?
For trapezoidal (keystone) distortion, perform keystone adjustment.
Please note that depending on the projected picture and the projection con-
ditions, it may not be possible to eliminate keystone distortion completely.
Is the lens properly focused?
Are the screen and projector installed at the proper distance?
Does the projection distance exceed the focusing range?
Is there condensation on the lens, etc.?
If the projector is moved from a cool storage area to a warm place and the
power is turned on, condensation may form on the lens or internal optical
parts. If this happens, wait until the condensation has evaporated before
using the projector.
For a computer input, are the horizontal and vertical positions properly ad-
justed?
Does the input signal have a compatible resolution and frequency? Check
the computers resolution.
If the image is crushed in the horizontal or vertical direction or if it is not
displayed over the entire screen, select a different aspect ratio.
When inputting component signals, is Color Space setting correct?
For a composite input, is Tint properly adjusted?
From the menu, select Image and adjust the Picture Adj. and Fine Picture.
Other than [Settings], [Option] and [Information], selection will not be pos-
sible unless a signal is being input to the projector and the image/picture is
projected.
Are the remote control units batteries worn? Replace with new batteries.
Is there an obstacle between the remote control unit and the projectors
remote control signal sensor?
Is the remote control unit outside of range?
Are you pointing the remote control units transmitter towards the projectors
remote control signal sensor?
See When an indicator is lit or flashing.
Power does not turn on
No image is produced
Image is distorted
Image is out of focus
Image is not in proper
position and is not
displayed properly
Video image is crushed
Colors of the overall image
are strange
Characters flicker or colors
are offset for RGB inputs
Cannot select the menu
name
Remote control unit does
not operate
STATUS indicator is lit red
or flashing red
Problem
Check
Reference
Page
E-23
E-66
E-61
E-61
E-28
E-1820
E-60
E-69
E-47
E-61
E-56
E-47, 48
E-26
E-31, 53
E-27
E-15, 16
E-15, 16
E-48
E-69
E-29
E-50
E-47
E-47, 48
E-11, 12
E-13
E-13
E-13
E-61